![]() To view a clip in the Source Monitor, you can drag the clip into the Source Monitor from the Project panel or double-click the clip that you want to view. Audio clips will appear as waveforms, as shown below. In addition, you can have more than one clip open in the source monitor and switch back and forth between them. These views allow you to view all types of content in the Source Monitor, from video clips to audio to images. Vect/YC Wave/RGB Parade shows the Vectorscope, YC Waveform, and RGB parade. Vect/YC Wave/YCbCr Parade shows the Vectorscope, YC Waveform, and YCbCr parade. RGB Parade displays the R (red), G (green), and B (blue) components separately. YCbCr Parade displays the Y, Cb, and Cr components in IRE. YC Waveform is used for adjusting brightness and contrast. A vectorscope measures a clip's color characteristics. This displays a wave form monitor, vectorscope, YCbCr parade, and RGB parade. This shows the transparency of a video or image.Īll Scopes. It is also the primary mode.Īudio Waveform shows the audio waveform, as you will see.Īlpha. This mode displays video in normal mode. Then ten views are listed in the menu above. They are:Ĭomposite Video. The panel menu is located in the upper right hand corner of the Source Monitor panel. To locate the views, go to the panel menu. The Source Monitor offers ten different views as compared to two in the Project panel. But there's actually much more to it! We are going to talk about: The main purpose of the Source Monitor is to allow you to view your clips at full resolution and establish In and Out points. That description makes the Source Monitor sound simple, and it makes its purpose seem minimal. After all, you can set In and Out points in the Project panel.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |